CCE 2017

ifai2016

Where: Munich, Germany

When: 21-23.03.2017

Zemat stand: Hall B6. Stand 527

TECHTEXTIL 2017

ifai2016

Where: Frankfurt, Germany

When: 09-12.05.2017

Zemat stand: Hall 3.0, stand E24

Made Expo 2017

fachack 2016

Where: Milano, ITALY

When: 08-11.03.2017

S.M.R.E./Zemat stand: Hall: 01, Stand: T01U10

Super Corr 2016

Supercorr2016

Where: Orlando, FL, USA

When: 17-20.10.2016

Zemat stand: SOON

Plywood, MDF, OSB forming

What is MDF? Medium Density Fiberboard (MDF) is an engineered wood product formed from wood fibers obtained by breaking down hardwood and softwood using a defibrator. The wood fibers are then glued together using wax and resin adhesive and made into panels by applying high temperature and pressure.

What is Plywood?Plywood is made from good log called peelers. Thin layers are peeled from the wood by rotating it along its horizontal axis. The sheets of veneer thus obtained are cut to the desired dimensions, dried, patched, glued together and then baked in a press at 140 °C (284 °F) and 1.9 MPa (280 psi) to form a plywood panel.

Strength and durability MDF is not as hard as plywood and can be damaged easily when handled rough. It is not as stiff as plywood and can sag with weight when used as shelves without reinforcement.

The cross graining of plywood improves dimensional stability by reducing expansion and shrinkage equating. The strength of panels is consistent across both directions. Moreover, the odd number of sheets reduces warping. Another advantage of plywood is that extreme cold does not affect its dimensions or strength.

Wood forming technology (for plywood, MDF boards, floor panels, etc.) with the use of ZEMAT brand Radio Frequency (RF) Generators and custom designed Hydraulic Presses is the best and the most economical solution for manufacturers making short series of products and requiring energy efficient, fast and easy production process.

Thanks to the use of RF technology the cost of tooling (moulds) is several times lower than with the use of traditional methods of wood forming. The raw material is places inside the mounted on the press table mould and after closing the high hydraulic pressure is applied. Then the RF frequency is turned on to start the heating process. The RF heating can be roughly compared to that of a microwave oven. Another words the heating take place inside of the molded material not on the surface of the mould.

This technology is extremely energy efficient and fast. The average time for forming/gluing process is between 2-20 minutes relative to the thickness and surface of the raw material. It is also environmentally friendly since it does not produce any harmful vapors or steam.